Directed Directechs DB3 Instrukcja instalacji - Strona 4

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle connections" following the installation diagram.

Connect the hood switch if factory equipped. If NOT, a hood switch must be installed and connected to the remote starter.

Autolights Interrupt ONLY required if vehicles are equipped with Autolights.

AUX1 and AUX2 are only available to control sliding doors on the Sienna using firmware 3.00 +.

General notes: This section highlights important information for this specific firmware.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D

[1]

The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin or

[2]

NOT supported in data.

Autolights Interrupt ONLY required if vehicles are equipped with Autolights.

[3]

Some Toyota 2010+ models have different encryption types. Please look at your key blade and identify the markings.

H-stam ped keys

For vehicles with H-stamped keys, see

the TL10 firmware.

403.TL5 4.00 2012 Toyota Avalon (G Key)

G-stam ped keys

For vehicles with G-stamped keys, see

the TL5 & TL7 firmware.

Keys required for

programming

operation

Standard Key

For vehicles with dot-stamped keys,

see the TL11 firmware.

Note:

Some replacement keys

may not have any markings on

the key.