Clarke CBM 2B Instrukcja obsługi i konserwacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke CBM 2B. Clarke CBM 2B 19 stron. Mortising machine

14. KEEP CHILDREN AWAY. All visitors should be kept a safe distance from the work

area, especially whilst operating the unit.

15. MAINTAIN MACHINE IN TOP CONDITION. Keep tools sharp and clean for the

best and safest performance. Follow maintenance instructions.

16. DON'T OVERREACH. Keep your proper footing and balance at all times. For best

footing, wear rubber soled footwear. Keep floor clear of oil, scrap wood, etc.

17. WEAR PROPER APPAREL. Loose clothing or jewellery may get caught in moving

parts. Wear protective hair covering to contain long hair.

18. BE AWARE that accidents are caused by carelessness due to familiarity. ALWAYS

concentrate on the job in hand, no matter how trivial it may seem.

ADDITIONAL SAFETY INSTRUCTIONS for MORTISING ACHINES

1. DO NOT USE until unit is completely assembled and installed according to

these instructions.

2. IF YOU ARE NOT thoroughly familiar with the operation of mortising machines,

obtain advice from a qualified person.

3. ENSURE the machine is secured to a workbench to prevent it from tipping

over during operation.

4. NEVER TURN MORTISING MACHINE ON before clearing the table of all objects

(tools, scrap pieces, etc.).

5. ALWAYS KEEP hands, fingers and hair well away from the rotating bit.

6. DO NOT ATTEMPT to mortise materials that do not have a flat surface, unless a

suitable support is used.

7. ALWAYS use the 'Hold Down' to prevent work from lifting when withdrawing

the chisel.

8. ALWAYS SUPPORT workpiece securely against fence to prevent rotation.

9. ENSURE chisel and bit is sharp, undamaged and properly secured before use.

10. ENSURE the chuck key is removed before starting.

11. NEVER START the Machine with the drill bit or chisel pressed against the

workpiece.

12. NEVER PERFORM LAYOUT, assembly or set-up work on the Machine with the

cutting tool rotating.

13. ALWAYS ADJUST DEPTH STOP to avoid drilling into the table.

14. ALWAYS STOP the machine before removing scrap pieces from the table.

15. SHUT OFF POWER, remove the drill bit and chisel and clean the table before

leaving the machine.

16. NEVER PLACE YOUR FINGERS in a position where the drill or cutting tool could

contact them if the workpiece should shift unexpectedly.