Clarke CBS16 Instrukcja obsługi i konserwacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke CBS16. Clarke CBS16 13 stron. Electric drill bit sharpener
Drukuj stronę
MAINTENANCE
CHANGING THE WHEEL
1. Make sure that the sharpener is switched off and disconnected from the
mains power supply.
2. Remove the two screws that hold
the head assembly in place and
remove the head assembly.
3. Remove the wheel assembly.
• Make sure the spring
underneath stays in place.
4. Unscrew the adjustment cylinder
from the wheel base by turning
clockwise.
5. Prise out the washer (#6).
6. Pop out the wheel base and
remove the worn grinding wheel.
7. Press new grinding wheel onto the
wheel base, replace the washer,
and screw the adjustment
cylinder back in.
8. Replace wheel assembly onto the
unit.
• Make sure that the inner flats of
the adjustment cylinder line up
with the outer flats of the drive spindle.
9. Replace the head assembly and screws.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8