Clarke CMPS2 Instrukcja obsługi i konserwacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke CMPS2. Clarke CMPS2 17 stron. Metalworker multi purpose sharpener
Drukuj stronę
2. Remove the drill clamp from the
clamp holder and insert a drill bit
such that the bit tip is either flush
with the end face of the holder or
protrudes a small amount. Grip
the bit lightly with the drill clamp
so that the drill can still move.
3. Slide the drill clamp into the
grooves in the holder and slide
the V-guide towards the drill
clamp as far as it will travel.
4. Slide the drill bit towards the V-
guide and rotate it until it seats
snugly within the V profile and
such that the ground edges are
vertically above each other.
5. Without rotating the bit, push the
bit forward within the clamp until
the bit tip touches the metal end
stop.
• The V-guide will slide
backwards as the drill bit is
advanced.
• This will set the drill bit with its
cutting edges vertically above
each other, so that the bit can
be sharpened equally on both its edges.
6. With the bit in this position, tighten
the clamp and remove it,
complete with the drill bit.
7. Transfer the clamp from the
setting position to the sharpening
position.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7