Clarke Contractor CON750 Instrukcja obsługi i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke Contractor CON750. Clarke Contractor CON750 17 stron. Contractor jigsaw
Również dla Clarke Contractor CON750: Instrukcja obsługi i konserwacji (20 strony)
Drukuj stronę
2. Adjust the pendulum control to
suit the material being cut using
the following suggested settings
as a starting point if required.
NOTE: Do not use the pendulum
action for cutting ceramics or
metals.
• Ceramics
• Metal
• Plywood, plastics
• Timber, fibreboard & chipboard 1-3
CUTTING DIFFERENT MATERIALS
CUTTING WOOD
Check that any previously used timber being sawn does not contain any nails
or other metal objects which would damage the blade.
CUTTING METAL
Having chosen a suitable blade for cutting metal it is recommended to
lubricate the material and blade with cutting oil to prevent the tool from
overheating. Support the workpiece with wooden blocks on either side.
ADJUSTING THE SOLE PLATE
The sole-plate is adjustable so that bevels of up to 45° may be cut. Loosen the
two socket head screws under the sole-plate before adjusting it to the desired
angle and re-tightening the screws.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
0
0
1-2
10