Clarke CPSB100B Instrukcja obsługi i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke CPSB100B. Clarke CPSB100B 17 stron.

TO START BLASTING

NOTE: Start with all valves in the closed position. Following the instructions

below will help prevent clogging in the delivery hose, outlet

manifold and the gun.

1. Connect the compressor to the

inlet connector.

2. Start the compressor and open

the air supply valve, see Fig 10.

• The tank will start to pressurise.

3. Test the safety valve by pulling on

the valve as shown in Fig 11.

• Air will hiss out when the valve is

pulled.

4. Open the throttle valve, Fig 12.

5. Check for leaks at the filler cap

and along all hoses and fittings as

the system pressurises. If leaks are

observed, release the pressure

from the tank and repair any leaks

immediately.

6. Squeeze and hold the trigger until

air is flowing through it.

7. With the trigger open, slowly open

the abrasive control valve as

shown in Fig 13 until abrasive

begins to flow out of the nozzle.

8. Adjust the abrasive medium

control valve until the desired

amount of abrasive material is

flowing through the gun.

9. Begin blasting.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Fig 10

Fig 11

Fig 12

Fig 13