ALE TC Series Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drukarka ALE TC Series. ALE TC Series 18 stron.

Check that all dots are operating : press arrow down

●

paper in front of the print-head. You should print a solid black rectangle (Fig. 18),

with no white lines across. Otherwise (Fig. 19)prime again using the "Norm" option

(Right arrow

are operating.

Fig. 18: Correct black pad

When the printing is correct, the collecting bucket can be removed (Fig. 13).

●

carefully clean the print-head (Fig. 17).

●

Exit the prime menu of the controller (

●

Set the system for printing back on your production line.

●

Prime the system using the prime switch :

Alternatively, you can use the prime switch to prime the print-head instead of using the

controller keyboard. This can be useful if the print-head is too far away from the controller.

See chapter

2.3 To enable the prime switch

To make a test print :

On the controller keypad, press the "arrow up"

–

(message 00).

Press the

–

Hold a piece of paper in front of the print-head. Briefly press right arrow

–

simultaneously pass the piece of paper across right to left. The result should be

similar to Fig. 21.

TC series print-heads Operator Manual

Design • Print • Trace

in the "Prime" menu) and a bucket (Fig. 13) and check again if all dots

key : the screen will then show PRINT OFF.

Fig. 19: Incomplete black pad

07/07/2011

whilst moving a sheet of

to select the test message

and