Directed Directechs DB3 Instrukcja instalacji - Strona 16

Feature programming

To enter feature programming routine:

Turn the ignition ON, then OFF.

2. Within 5 seconds, press and hold the programming button until the LED turns ON orange (after 3 seconds).

3. Release the programming button.

The LED will flash green once slowly to indicate the feature number is 1. After a short delay, the LED flashes red rapidly to indicate the

current option of feature 1 (e.g. 1 x green followed by 1 x red indicates feature 1 is set to option 1). The flashing sequence will repeat

until a new command is entered.

Changing feature options:

Press the lock/arm or unlock/disarm button on the aftermarket transmitter to change the option of the selected feature.

The LED flashes red rapidly the number of times equal to the current option number. After a short delay, the LED flashes green slowly the

number of times to indicate the current feature. The flashing sequence will repeat until a new command is entered.

Accessing another feature:

Press and release the programming button a number of times to advance from the current feature to the next desired feature.

The LED flashes green slowly the number of times equal to the feature number. After a short delay, the LED flashes red rapidly to indicate

the current option of the current feature. The flashing sequence will repeat until a new command is entered. When the maximum number

of features or options is reached, the LED will start flashing again from the first feature or option.

Exiting feature programming:

To exit feature programming, press and hold the programming button for 3 seconds or ensure there is no activity on the interface for 30

seconds. The LED will turn ON orange for 2 seconds to confirm the end of the programming sequence.

403.VW18 2.05 2024 Volkswagen Jetta GLI (Smart Key)