Zanussi ZBB 6286 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka Zanussi ZBB 6286. Zanussi ZBB 6286 20 stron. Zanussi washer dryer brochure
Również dla Zanussi ZBB 6286: Specyfikacja (5 strony), Specyfikacje (7 strony), Instrukcja obsługi (32 strony)

Drukuj stronę

SOMETHING NOT WORKING

Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or

installation a charge will be made, even if the appliance is under guarantee.

Before contacting your local Service Force Centre, check the following points:

Symptom

No power to the appliance

The light does not come on

The temperature in the fridge or freezer section is

too high

The freezer door will not open

The compressor runs continously

Excessive frost and ice has built up

Noise

Water under the salad bin

Solution

Check there is power at the socket.

Check there is not a power cut by checking the

household lights.

Check the fuse has not blown.

Ensure that the bulb is correctly fitted.

Replace the bulb if it has blown.

Check the door light switch is not jammed.

Check the thermostat control knob mounted in the

cross piece between the fridge and freezer is turned

to the correct setting relative to ambient conditions.

Check the ambient temperature is within the

appliance's operating limits, please refer to the

installation section in this instruction book.

Relocate the appliance if necessary.

Has door just been opened? If so leave for a few

minutes to allow the air pressure to equalise.

Adjust the thermostat control knob to give correct

temperature control. See "Setting the temperature".

Check that the doors are closed.

Large quantities of food have recently been placed in

the cabinet and/or door is frequently opened.

Check that air ventilation is not obstructed.

Ensure the doors are not left open.

Check that nothing is preventing the doors from

closing.

Is the door gasket intact and clean.

Refer to normal operating sounds.

Check the drain hole is not blocked. (see

Maintenance and Cleaning).