Zanussi ZRD 23 JC Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka Zanussi ZRD 23 JC. Zanussi ZRD 23 JC 17 stron. Combination

Put the mains plug into the mains socket and put foods

taken out back to their places.

It is recommended to operate the appliance at the highest

position of the thermostatic control for some hours so that

it can reach the sufficient storing temperature as soon as

possible.

Regular cleaning

It is recommended to wash the inside of the refrigerator

in 3-4 weeks time using lukewarm water then wipe it (it is

practical to clean the inside of the freezer and defrost it at

a time).

Household cleaner or soap must not be used.

After breaking the circuit wash the appliance with luke-

warm water then wipe it. Clean the door gasket with

clean water. After cleaning apply voltage to the appli-

ance.

It is recommended to remove the dust and dirt collected

on the back of the refrigerator and the condenser and to

clean the evaporative tray on top of the compressor once

or twice a year.

In case the appliance will not be used for a long time fol-

low these steps:

Break the circuit of the appliance.

Remove foods from the refrigerator.

Defrost and clean it as written before.

Leave the door open to avoid a build up of air inside.

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Unscrew the plate screw fixing the lamp cover, then take

the lamp cover off in the direction of arrow and the bulb

can be changed. (Type of the bulb: Mignon 322, 230 V,

15 W, E 14 thread)

After changing bulb replace the lamp cover, screw the

plate screw and apply voltage to the appliance.

The lack of light does not influence operation of the

refrigerator.