Zanussi ZRT23100XA Podręcznik użytkownika - Strona 15
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Lodówka Zanussi ZRT23100XA. Zanussi ZRT23100XA 48 stron.
Drukuj stronę
After maintenance, connect the mains plug to
the mains socket.
Automatic defrosting of the fridge
The removal of frost occurs automatically
when the motor compressor stops during op-
eration.
The water drains out through the drain hole
and collects in the water container where it
evaporates.
The water container is behind the appliance,
above the motor compressor.
The drain hole is in the fridge on the rear part.
To prevent water to collect in other parts of
the fridge, make sure that the drain hole is al-
ways clean. Use the cleaning tool that is in the
drain hole.
Defrosting of the freezer
There can be frost on the freezer shelves
and around the top compartment.
Defrost the freezer when the layer of frost has
a thickness of 3 or 5 mm.
Caution! Do not use sharp metal tools to
remove the frost.
Do not use mechanical devices to defrost the
freezer.
1. Deactivate the appliance.
2. Remove all the food from the freezer. Wrap
the food in newspaper and keep it at a
cold temperature.
3. Keep the appliance door open until de-
frosting is completed.
4. Clean and fully dry the freezer.
5. Connect the mains plug to the mains sock-
et.
www.zanussi.com
6. Activate the appliance.
7. Set the temperature knob at the highest
position and let the appliance operate for 2
or 3 hours with this setting.
8. Put back the food in the freezer.
When the appliance is not used for long
periods
1. Deactivate the appliance and disconnect
the mains plug from the mains socket.
2. Remove all the food.
3. Defrost the appliance.
4. Fully clean and dry the appliance and all
the accessories.
5. Keep the doors open to prevent unpleas-
ant smells.
Replacing the lamp
1. Disconnect the mains plug from the mains
socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover
4. Replace the old lamp with a new one. Use
only lamps for household appliances. The
lamp cover shows the maximum power of
the lamp.
5. Install again the lamp cover.
6. Connect the mains plug to the mains
socket.
The type of light bulb or halogen lamp
used for this appliance, is only for house-
hold appliances. Do not use it for house light-
ning.
15