Zanussi ZU 7115 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka Zanussi ZU 7115. Zanussi ZU 7115 16 stron. Larder-refrigerator
Również dla Zanussi ZU 7115: Instrukcja obsługi (20 strony)

Drukuj stronę

The electrical connections

WARNING: THIS APPLIANCE MUST BE

EARTHED.

The manufacturer declines any liability

should this safety measure not be observed.

If the plug that is fitted to your appliance is not

suitable for your socket outlet, it must be cut off

and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to

prevent the hazard of shocks in case it should

be plugged into a 13amp socket in another part

of your home.

Important

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow

Blue

Brown

If you fit your own plug, the colours of the wires

in the mains lead of your appliance may not

correspond with the markings identifying the

terminals in your plug, proceed as follows:

GREEN & YELLOW

BLUE

D207

Connect the Green and Yellow (earth) wire to

the terminal in the plug which is marked with the

letter «E» or the earth symbol

green and yellow.

Connect the blue (neutral) wire to the terminal in

the plug which is marked with the letter «N» or

coloured black.

Connect the brown (live) wire to the terminal in

the plug which is marked with the letter «L» or

coloured red.

The plug moulded onto the lead incorporates a

- Earth

- Neutral

- Live

Fig.13

13 AMP. FUSE

BROWN

CORD CLAMP

or coloured

fuse. For replacement, use a 13amp BSI362

fuse. Only ASTA or BSI approved fuses should

be used.

The plug must not be used if the fuse

cover/carrier is lost. The cover/carrier is indicated

by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained

from your local Zanussi Service Force Centre

whose address is listed in the Customer Care

Booklet which accompanies your instruction

manual.

This appliance complies with the E.E.C.

Directive No. 87/308 of 2.6.87 relative to radio

interference suppression.

This appliance complies with the

following E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive)

and subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Please ensure that when the appliance is

installed it is easily accessible for the

engineer in the event of a breakdown.