Zanussi EOB 340 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piekarnik Zanussi EOB 340. Zanussi EOB 340 11 stron. Zanussi electric oven

Fit the appliance into the cabinet recess.

Open teh oven door and secure the oven to the kitchen

cabinet with four wood screws, which fit the holes provided

in the oven frame (Fig.12).

When installing an electric plate hob over the oven, the

hob's electrical connection and the oven's one have to be

carried out separately, for security reasons and to let the

oven be taken off the unit easier, if necessary.

Before the appliance is connected:

1) check that the main fuse and the domestic installation

can support the load;

2) check that the power supply is properly earthed in

compliance with the current rules;

3) check the socket or the double pole switch used for the

electrical connection can be easily reached with the

appliance built in the forniture unit.

This appliance is delivered without an electric supply

cable, therefore, you will have to fit to it a supply cable

with standard plug, suitable for the total electric load

shown on the rating plate. The plug is to be inserted into

a suitable wall socket.

If connecting the appliance directly to the electric system, a

double pole switch must be installed between the appliance

and the electricity supply, with a minimum gap of 3 mm.

between the switch contacts and of a type suitable for the

required load in compliance with the current rules. The earth

wire must not be interrupted by the double switch pole.

The connection cable has to be placed in order that, in each

part, it cannot reach a temperature 50 °C higher than the

room temperature.

After the connection is carried out, test the heating elements

for about 3 minutes.

Suitable power supply cables are the following types,

considering the respective necessary section of cable.

H07 RN-F

H05 RN-F

H05 RR-F

H05 VV-F

The oven has an easily accessible terminal block, which

is meant to work with an electric single-phase rate of 230

The manufacturer disclaims any

responsability should all the safety

measures not be carried out.

Fig. 12

Fig. 13