Zanussi ZOG10311XK Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piekarnik Zanussi ZOG10311XK. Zanussi ZOG10311XK 25 stron.
Również dla Zanussi ZOG10311XK: Podręcznik użytkownika (24 strony)

Zanussi ZOG10311XK Podręcznik użytkownika
burner area, as shown in "Product description"
chapter.
INITIAL CLEANING
Remove all accessories and removable shelf
supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories before first
use.
Put the accessories and the removable shelf
supports back to their initial position.

DAILY USE

WARNING! Refer to Safety chapters.
IGNITION OF OVEN GAS BURNER
Oven safety device:
The gas oven has a thermocouple. It
stops the gas flow if the flame goes
out.
1. Press the knob for the gas control and turn it to
.
2. Keep the knob for the gas control pushed for
15 seconds or less to let the thermocouple
warm up. Do not release the knob until the
KNOB FOR THE GAS CONTROL
Symbol
Conventional Cooking
Grilling
6
Heat from the bottom of the oven. Range of temperature adjustment
(150 °C - 250 °C).
Heats from the top.
PREHEATING
Preheat the empty appliance before first use.
1. Set the maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function
4. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
Let the oven cool down. Dampen a soft cloth with
warm water and a little mild washing-up liquid and
use this to clean the oven cavity.
flame ignites, otherwise the gas flow is
interrupted.
Do not keep the knob for the gas control pushed
for more than 15 seconds. If the oven burner does
not ignite after 15 seconds, release the knob for the
gas control, turn it into off position, open the oven
door. Wait minimum 1 minute, close the oven door
and try to ignite the oven burner again.
AFTER IGNITING THE OVEN GAS BURNER
1. Release the knob for the gas control.
2. Turn the knob for the gas control to set the
temperature.
Control the flame through the holes in the cavity
bottom plate.
Function
.