Zanussi FCS 920 C Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz Zanussi FCS 920 C. Zanussi FCS 920 C 48 stron.
Drukuj stronę
• The light is lit: the door cannot be opened.
• The light is out: the door can be opened.
Before first use
Warning!
Ensure that the electrical and water connections comply
with the installation instructions.
Important! Remove any material from the drum.
Important! We recommend you to run a wash programme
without any load, to clear any residues which may have
Daily use
Load the laundry
Open the door by carefully pulling the door handle out-
wards. Place the laundry in the drum, one item at a
time, shaking them out as much as possible. Close the
door.
Measure out the detergent and the fabric softener
Pull out the dispenser
drawer until it stops.
Measure out the amount of
detergent required, pour it
into the larger compart-
ment on the left
.
If required, pour fabric
softener into the smaller
compartment marked
(the amount used must not
exceed the «MAX» mark
in the drawer). Close the
drawer gently.
• The light is flashing: the door can soon be opened.
been left by the manufacturing process. Pour approx. 100
ml of detergent straight into the drum and run a cotton
cycle at 60°C. When the programme is finished the
machine will be ready to use.
Select the required programme by means of the
programme selector dial (9)
Turn the programme selector dial to the required pro-
gramme. The selector can be turned either clockwise or
anticlockwise.
The green light of button 6 starts to flash
On programme progress display the pilot lights corre-
sponding to all phases composing the selected pro-
gramme are lit.
On position
the programme is reset and the machine
is switched OFF.
At the end of the programme the selector dial must be
turned to position
to switch the machine off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the
lights in the programme progress display will start to flash
to indicate a wrong selection. The machine will not
perform the new selected programme.
Select the spin speed, Rinse Hold or No spin option
(8)
Select the spin speed, Rinse Hold option or No Spin op-
tion by turning the spin speed selector.
For the maximum spin speed allowed by each pro-
gramme, refer to the chapter Washing programmes.
• The position 900 is equivalent to 900 rpm/min for the
synthetic and wool programmes and 700 rpm/min for
the delicate wash programme.
• The position 500 is equivalent to 500 rpm/min for all
the wash programmes.
7