Zanussi FE 904 NN Podręcznik użytkownika - Strona 20
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz Zanussi FE 904 NN. Zanussi FE 904 NN 22 stron. Washing machine fe 904 nn
Drukuj stronę
Something not working?
Problems which you can resolve yourself.
During machine operation it is possible that the END pilot light
working:
1 flash = the machine does not fill
2 flashes = the machine does not empty
4 flashes = the door has not been closed
At the same time the buzzer sounds.
Once the problem has been eliminated, press the START/PAUSE button
all checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
flashes to indicate that the machine is not
to restart the programme. If after
Possible cause
• The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The START/PAUSE button
depressed.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The RINSE HOLD
option has been selected.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cover of the drain pump has not been
correctly screwed in after cleaning.
• The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
20
has not been
or SPIN SUPPRESSION