Zanussi FJ 1296 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Zanussi FJ 1296. Zanussi FJ 1296 19 stron. Zanussi washing machine instruction booklet fj 1296

Drukuj stronę

1. Control Panel

INSTALLATION

Unpacking

Before starting the machine up, the packing must be

removed as follows.

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

P0255

P0234

Remove the polystyrene block from the bottom of the

machine.

Carefully slide out the right polythene bag (1), removing

it toward the centre of the machine.

Repeat the operation for the left polythene bag (2),

removing it toward the centre of the machine.

P0256

P0001

Slide out the 3 plastic spacers and plug the 3 holes with

the 3 plastic plugs which you can find at the back of the

machine.

Using a spanner unscrew

and remove the rear right

bolt. Lay the machine

gently on its back, making

sure that the hoses are

not squashed.

P0233

Remove the polystyrene

base, set the machine

upright and unscrew the

two remaining rear bolts.

P0002

Positioning

Your new washing machine has been designed to be

permanently plumbed in to your home's water supply

and drainage system. However, if this is not possible, it

may be connected to suitable existing taps with the drain

hose discharging into a sink.

The appliance has two inlet hoses, hot and cold, with

female 3/4" BSP thread connectors. If this connection is

not compatible with the plumbing of the existing installa-

tion, a variety of connectors are available from good

hardware stores and plumbers merchants to suit most

domestic plumbing. Any alteration to your existing plum-

bing must be carried out by a competent person, or qua-

lified plumber.

Water inlet

The inlets on the back of the appliance are colour coded,

blue for cold and red for hot.

P0003

If only a cold water supply is available, connect the two

hoses to a cold water outlet by means of a «Y» connec-

tion piece.

Installation should comply with local water authority and

building regulations' requirements.

The appliance must be given a separate cold water sup-

ply and not be connected to a mixer tap, a single outlet

water heater or a booster pump. A minimum water pres-

sure of 7 psi is required for safe operation of the appli-

ance.

If you cannot make the cold water connection direct from

the rising mains, you may be able to operate the appli-

ance from your cold water storage system.

There should be a minimum distance of 5.02m (16

between the appliance's inlet and the bottom of the tank.

There will be sufficient pressure for the hot water supply

from the hot water cylinder if the height between the

appliance's inlet and the bottom of the cold water stor-

age cistern (not between the appliance and hot water

cylinder) is at least 2.74m (9ft).

P0021

Before connecting the

hoses be sure to fit the

mesh filters supplied as

per diagram.

1 /

Set the hoses correctly by

loosening the ring nuts.

After positioning the inlet

hoses, be sure to tighten

the ring nuts again to pre-

vent leaks.

ft)