Zanussi FJ 1354 S Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Zanussi FJ 1354 S. Zanussi FJ 1354 S 26 stron. Zanussi instruction washing machine fj 1054 w fj 1254 w fj 1354 s fj 1454 w
Drukuj stronę
6 OPTIONS button
Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
•
AA 40°: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C and higher.
If you select 40°C , the machine will prolong the time
at 40°C in the washing phase, this will allow an A
class in energy efficiency and washing performance to
be achieved.
If you select 90°C and press the AA 40° button, the
washing temperature will be reduced from 90°C to
60°C.
If you select 60°C or 50°C and press the AA 40°
button, the washing temperature will be reduced to
40°C. In both cases the washing time will be
prolonged.
•
QUICK: select this option for laundry that is only
slightly soiled.
The washing time will be reduced according to the
type of fabric and the selected temperature.
The PREWASH, the QUICK and AA 40°options
cannot be selected together.
Important!
The first time you use the washing machine, when
you switch it on, it may give an audible warning signal.
This is due to the fact that the washing machine has
performed a washing cycle during the manufacturer's
inspection tests, and this cycle has not been erased after
its completion.
7 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the programme,
press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
• Draining of water and spinning after the execution of
programmes with the RINSE HOLD option.
8 SKIP/RESET button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the SKIP/RESET button
must be pressed once or repeatedly to clear the
programme memory. All the lights must be off.
If the previous programme is not cleared, an audible
signal will sound, when you switch the machine on.
7