Zanussi FJS 1072 HV Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Zanussi FJS 1072 HV. Zanussi FJS 1072 HV 21 stron. Washing machine fjs 1072 hv

All transit bolts and packing must be

removed before using the appliance.

You are advised to keep all transit devices so that

they can be refitted if the machine ever has to be

transported again.

1. Using a spanner, unscrew and remove the rear

right-hand bolt and lay the machine on its

back, taking care not to squash the hoses.

This can be avoided by placing one of the

corner packing pieces between the machine

and the floor.

2. Remove the polystyrene block from the bottom

of the machine and release the two plastic

bags by removing the adhesive strip.

3. Carefully remove the right-hand bag (1) then

the left-hand bag (2) by pulling them towards

the centre of the machine.

4. Set the machine upright and remove the two

remaining bolts from the back.

5. Pull out the three plastic spacers from the

holes into which the bolts were fitted.

6. Plug the open holes with the plugs which you

will find at the back of the appliance.

Install the machine on a flat hard floor.

Make sure that air circulation around the machine

is not impeded by carpets, rugs etc. Check that

the machine does not touch the wall or other

kitchen units.

Carefully level by screwing the adjustable feet in

or out. Never place cardboard, wood or similar

materials under the machine to compensate for

any unevenness in the floor.

After having levelled the machine, tighten the lock

nuts.

INSTALLATION

P0255

P0234

P0256

P0254

P0233

P0020

P0509