Zanussi FJS 1084 C Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Zanussi FJS 1084 C. Zanussi FJS 1084 C 22 stron. Washing machine fjs 1084 c
Również dla Zanussi FJS 1084 C: Instrukcja obsługi (21 strony)

Drukuj stronę

Water inlet

Connect the water inlet hose to a tap with a 3/4"

thread after having inserted the small filter "A"

supplied with the machine.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply loosen

the fitting, rotate the hose and retighten the fitting,

making sure there are no water leaks.

The inlet hose must not be lengthened. If it is too short

and you do not wish to move the tap, you will have to

purchase a new, longer hose specially designed for

this type of use.

Water drainage

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the plastic

hose guide supplied with the machine. In this case,

make sure the end cannot come unhooked when the

machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm

above the ground.

Directly into a drain pipe at a height of not less than

60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated,

i.e. the inside diameter of the drain pipe must be

larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the

floor; only the part near the drainage point must be

raised.

Electrical connection

This machine is designed to operate on a 220-230 V,

single-phase, 50 Hz supply.

Check that your domestic electrical installation can

take the maximum load required (2.2 kW), also taking

into account any other appliances in use.

Connect the machine to an earthed socket, in

accordance with current wiring regulations.

The manufacturer declines any responsibility

for damage or injury through failure to comply

with the above safety precaution.

Should the appliance power supply cable

need to be replaced, this should be carried

out by our Service Centre.

P0003

P0022

P0023

P0021