Zanussi FJS 1397 W Instrukcja obsługi - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Zanussi FJS 1397 W. Zanussi FJS 1397 W 28 stron. Zanussi instructrion manual front-load washer fjs 1197 w, fjs 1397 w, fjs 1597 w

Drukuj stronę

Electrical connection

Any electrical work required to install this appliance

should be carried out by a qualified electrician or

competent person.

WARNING: THIS APPLIANCE MUST BE

EARTHED.

The manufacturer declines any liability should

this safety measure not be observed.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the appliance's

rating plate. The rating plate is located at the top of the

rim of the open door.

The appliance is supplied with a 13amp plug fitted.

In the event of having to change the fuse in the plug

supplied, a 13amp ASTA approved (BS1362) fuse must

be used.

Should the plug need to be replaced for any reason,

proceed as described below.

The wires in the mains lead are coloured in accordance

with the following code:

Green and Yellow

Blue

Brown

The wire coloured green and yellow must be connected

to the terminal marked with the letter «E» or by the

earth symbol

or coloured green and yellow.

The wire coloured blue must be connected to the

terminal «N» or coloured black.

The wire coloured brown must be connected to the

terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure over

the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is

a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of

safely.

Should the appliance power supply cable need

to be replaced, this should be carried out by

our Service Force Centre.

- Earth

- Neutral

- Live

Mod. ..........

Prod. No. ...........

Ser. No. .........

P0042

GREEN & YELLOW

BLUE

CORD CLAMP

P1041

Permanent connection

In the case of permanent connection it is necessary that

you install a double pole switch between the appliance

and the electricity supply (mains), with a minimum gap

of 3mm between the switch contacts and of a type

suitable for the required load in compliance with the

current electrical regulations.

The switch must not break the yellow and green earth

cable at any point.

BROWN