Zanussi FL 1089ALU Podręcznik użytkownika - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz Zanussi FL 1089ALU. Zanussi FL 1089ALU 26 stron. Washing machine fl 1089; fl 1089alu; fl 1289
Drukuj stronę
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
• Draining of water and spinning after the
execution of programmes with the NIGHT WASH
(CICLO NOCHE) option.
11 RESET (ANULAR) button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the RESET (ANULAR) button to
exclude one or several phases of the programme
which is running, as indicated below:
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET (ANULAR) button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the phase(s) will go out).
Example:
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET (ANULAR) once or repeatedly to
cancel the previously performed programme (three
blinking dashes will appear on the display);
- select the type of fabric by means of button
TEJIDOS;
- select the special programme:
• RINSES
Depress RESET (ANULAR) once, the pilot light
WASH
goes out.
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
37
• SPIN
Depress RESET (ANULAR) twice, the pilot lights
WASH
and RINSES
• DRAIN
Depress RESET (ANULAR) three times, the
pilot lights WASH
go out.
Example:
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
TEJIDOS:
- select the special programme as previously
described.
12 DELAY (INICIO DIFERIDO) button
This button makes it possible to delay the starting of
the programme by up to 24 hours. The delay you
have selected is shown on the display for about 3
seconds; afterwards, the duration of the programme
reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to change or cancel the delay
time, proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button until the display shows the
desired delay time or
• press the DELAY button once, to erase the delay
time. The display will indicate "0h".
• press the START/PAUSE button again.
go out.
, RINSES
and SPIN
In this case the
machine will perform
the rinses and spin.