Directed Security and Remote Start Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Alarm samochodowy Directed Security and Remote Start. Directed Security and Remote Start 20 stron. Security and remote start
Drukuj stronęWiring Diagram
Control
Center
Antenna
LED
Button
Shock Sensor port
Wiring connections
Shock Sensor
(side view)
Main Harness (H1), 12-pin connector
H1/1
RED/WHITE
H1/2
RED
H1/3
BROWN
H1/4
H1/5
BLACK
H1/6
VIOLET*
H1/7
BLUE
H1/8
GREEN*
H1/9
BLACK/WHITE
H1/10
WHITE/BLUE
H1/11
WHITE
H1/12
ORANGE
* The door trigger wire will still need to be connected if the system is programmed with security features OFF to allow the system to enter the
programming modes.
H2 Harness, 6-pin connector
H2/1
LIGHT BLUE
H2/2
WHITE/BLACK
H2/3
VIOLET/BLACK
H2/4
GREEN/WHITE
H2/5
GRAY/BLACK
H2/6
LIGHT GREEN/BLACK
© 2012 Directed. All rights reserved.
Bitwriter
D2D port
Jumper
Jumper
tachometer
light ash
Sensitivity
Adjustment
(-) 200mA AUX TRUNK RELEASE OUTPUT
(+) CONSTANT POWER INPUT
(+) SIREN OUTPUT
NOT USED
(-) CHASSIS GROUND INPUT
(+) DOOR TRIGGER INPUT, ZONE 3
(-) INSTANT TRIGGER INPUT, ZONE 1
(-) DOOR TRIGGER INPUT, ZONE 3
(-) 200mA DOMELIGHT SUPERVISION OUTPUT
(-) REMOTE START ACTIVATION INPUT
(+)/(-) SELECTABLE LIGHT FLASH OUTPUT
(-) 500mA GROUND WHEN ARMED OUTPUT
(-) 200mA SECOND UNLOCK OUTPUT
(-) 200mA AUX 3 OUTPUT
(-) 200mA AUX 2 OUTPUT
(-) 200mA FACTORY ALARM REARM OUTPUT
(-) WAIT-TO-START INPUT
(-) 200mA FACTORY ALARM DISARM OUTPUT
Remote
Start port
Control Center button input (use blue 2-pin
connector from Control Center cable)
Control Center LED output (use white 2-pin
connector from Control Center cable)
To Remote
Start port
H
Relay
satellite port
5