Zanussi ZWY 71054SE Podręcznik użytkownika - Strona 15

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Spryskiwacz Zanussi ZWY 71054SE. Zanussi ZWY 71054SE 21 stron.

Drukuj stronę
Problem
The appliance does not fill
with water properly.
The appliance does not
drain the water.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
There is water on the floor.
You cannot open the appli-
ance lid.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the appliance shows other alarm codes (the
indicator of button
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
•
Make sure that the drain hose is in the correct position. The hose
may be too low.
•
Set the drain programme if you set a programme without drain
phase.
•
Set the drain programme if you set an option which ends with water
in the tub.
•
Set the spin programme.
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and there
is not water leakages.
•
Make sure that the drain hose have no damages.
•
Make sure you use the correct detergent and the correct quantity of
it.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion'.
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation'.
•
Add more laundry in the drum. The load may be too small.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you
wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Make sure that you press only the wanted button(s).
flashes in red). Deactivate
Possible solution
and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
15