Zanussi ZDW 416 BU Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Zanussi ZDW 416 BU. Zanussi ZDW 416 BU 16 stron. Dishwasher zdw 416 fs; zdw 416 bu

Drukuj stronę

MAINTENANCE AND CLEANING

Cleaning the central filters

(After each wash)

Inspect the central filters (B) and (C) and remove any

scraps of food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the

outer one (B) (pulling the central funnel upwards); the

smaller filter (C) can then be removed by pressing the

two tongues (D).

MA13

Once cleaned, refit the filters by pressing them

down until they click into place.

Cleaning the large filter

(Once a month)

Clean the large filter (A) on both sides under running

water, using a brush.

To take it out, remove the spray arm by pressing the

two tongues (E), turn the ring (F) anticlockwise

(towards the left) and then slide the whole part out.

Refit the filter following the above instructions in

reverse order.

MA01

Caution: the dishwasher must not be used

without filters.

Incorrect repositioning of the filters will produce

poor washing results.

Cleaning of the filters is vital to ensure correct

operation of the machine.

MA08

Internal and external cleaning

You must ensure that the seals around the door, the

detergent and rinse aid dispensers are cleaned

regularly with a damp cloth.

We recommend you carryout a maintenance wash

every 3 months, by running a 65° C wash programme

without dishes or using a specific dishwasher cleaner.

Check that the spray arm nozzles are not obstructed.

To remove the bottom spray arm, release it from its

securing catches and pull it out.

To clean the nozzles of the top spray arm, slide out

the top basket whereby the spray arm will become

accessible. To remove it, withdraw the central funnel

by pressing the two side tabs and unscrewing the

retaining ring.

Wash the spray arms under running water and refit

them in place.

Clean the external surfaces of the machine and

control panel with a soft damp cloth. If necessary use

only neutral detergents. Never use abrasive products,

scouring pads or solvents (acetone, trichloroethylene

etc...).

Prolonged periods of non-operation

If you are not using the machine for any period of time

you are advised to:

unplug the appliance and turn off the water;

fill the rinse aid dispenser;

leave the door ajar to prevent the formation of

unpleasant smells;

leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the

temperature is below 0°C.

If this is unavoidable, empty the machine, close the

water inlet tap, disconnect the water inlet pipe and

empty it.

Moving the machine

If you have to move the machine (you are moving

house etc...):

unplug it;

turn off the water tap;

remove the water inlet and discharge hoses;

pull the machine out together with the hoses.

Caution: avoid over tilting the machine during

transport.

PMA02GB