Zanussi ZT 695 Instrukcja obsługi - Strona 21

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Zanussi ZT 695. Zanussi ZT 695 24 stron. Zanussi instruction dishwasher zt 695

Drukuj stronę

Installation

Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person.

Any plumbing work required to install this

appliance should be carried out by a qualified

plumber or competent person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a

drain.

Levelling

Good levelling is essential for correct closure and sealing of

the door. When the appliance is correctly levelled, the door

will not catch on the levelling spacers on either side of the

cabinet. If the door does not close correctly, loosen or tighten

the adjustable feet until the machine is perfectly level.

Water supply connections

This dishwasher must be plumbed into a cold water supply.

The water pressure must be within the limits given in the

"Technical specifications" (Instruction Book - Part 2).

Your local Water Authority will advise you on the average

mains pressure in your area.

The dishwasher features fill and drain hoses which can be

turned either to the left or the right to suit the installation.

The locknut must be correctly fitted to avoid water

leaks.

Avoid bends or kinks in the hose which could prevent or slow

down the water supply.

If the machine is connected to new pipes or pipes which

have not been used for a long time, you should run the water

for a few minutes before connecting the inlet hose. This will

prevent deposits of sand or rust clogging the inlet hose.

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot, securing it if necessary with a

clip.

Attention!

Our appliances are supplied with a with a

security device to protect against the return of

dirty water back into the machine.

If the spigot of your sink has a "no return valve"

incorporated this can prevent the correct draining

of your dishwasher. We advise you therefore to

remove it.

2. Hooked over the edge of the sink using the special

curved plastic guide (if provided).

3. To a stand pipe provided with vent-hole, minimum

internal diameter 4 cm.

IN06

CS09

IN07