Zanussi PWL59 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob Zanussi PWL59. Zanussi PWL59 11 stron. Gas hob pwl59; pxl59

Drukuj stronę

Operation

This hob is provided with a safety device, which

will stop the gas flow if the flame accidentally goes

off during cooking.

To light a burner:

turn the relevant control knob anticlockwise to

maximum position and push it down to ignite;

upon ignition, keep the knob pushed down about

5 seconds, to allow the safety device to be switched

off;

then adjust the flame as required.

If the burner does not ignite, turn the control knob to

zero, and try again.

If you cannot light the flame even after several attempts,

check the "cap" and "crown" (Fig. 1, lett. A, B) are in the

correct position.

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Large (triple crown)

Medium (semi-rapid)

Small (auxiliary)

minimum

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

If you use a saucepan which is smaller than the

recommended size, the flame will spread beyond

the bottom of the vessel, causing the handle to

overheat.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

Take care when frying food in hot oil or fat, as the

overheated splashes could easily ignite.

If the control knobs become difficult to turn, please

contact your local Service Centre.

FO 0204

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1