Zanussi ZEM6740FBA Podręcznik użytkownika - Strona 12
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob Zanussi ZEM6740FBA. Zanussi ZEM6740FBA 20 stron.
Drukuj stronęProblem
The residual heat indicator does
not come on.
The Automatic Heat Up function
does not operate.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
comes on
comes on
comes on
and number comes on.
comes on
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rat-
ing plate, three digit letter code for the glass
12
Possible
The cooking zone is not hot be-
cause it operated only for a short
time.
The cooking zone is hot.
The highest heat setting is set.
The Power management is activa-
ted.
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cooking
zone.
Incorrect cookware.
The diameter of the bottom of the
cookware is too small for the
cooking zone.
There is an error in the appliance.
There is an error in the appliance
because a cookware boils dry.
The overheating protection for the
cooking zones and the Automatic
Switch Off operate.
ceramic (it is in the corner of the glass sur-
face) and an error message that comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer serv-
Remedy
If the cooking zone operated suf-
ficiently long to be hot, speak to
the service centre.
Let the cooking zone become
sufficiently cool.
The highest heat setting has the
same power as the Automatic
Heat Up function.
Refer to "Power management".
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and ac-
tivate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller
cooking zone.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
Deactivate the appliance. Re-
move the hot cookware. After ap-
proximately 30 seconds, activate
the cooking zone again. If the
cookware was the problem, the
error message goes out of the
display, but the residual heat indi-
cator can stay. Let the cookware
become sufficiently cool and refer
to "Cookware for the induction
cooking zone" to see if your
cookware is compatible with the
appliance.
www.zanussi.com