Zanussi ZEV6140NBA Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob Zanussi ZEV6140NBA. Zanussi ZEV6140NBA 12 stron.
Również dla Zanussi ZEV6140NBA: Podręcznik użytkownika (13 strony)
Drukuj stronę
• Scratches or dark stains on the surface have
no effect on how the hob operates.
• Use a special cleaner applicable for the
surface of the hob.
• Use a special scraper for the glass.
Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not, the
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the hob.
Residual heat indicator does not
come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
Installation
WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
www.zanussi.com
• Remove when the hob is sufficiently
Possible cause
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is released.
The zone is not hot because it
operated only for a short time.
surface). Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• For a single phase or two phase connection
• To replace the damaged mains cable use
dirt can cause damage to the hob. Put the
special scraper on the glass surface at an
acute angle and move the blade on the
surface.
cool: limescale rings, water rings, fat stains,
shiny metallic discoloration. Clean the hob
with a moist cloth and some detergent. After
cleaning, rub the hob dry with a soft cloth.
Check if the hob is correctly con-
nected to the electrical supply.
Refer to the connection diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
use the following (or higher) mains cable
type: H05BB-F Tmax 90°C.
the following (or higher) mains cable type:
Remedy
7