Zanussi ZGF 782 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob Zanussi ZGF 782. Zanussi ZGF 782 19 stron. Hob zanussi
Również dla Zanussi ZGF 782: Instrukcja obsługi (20 strony), Instrukcja obsługi (19 strony), Instrukcja obsługi (20 strony), Instrukcja obsługi (20 strony), Instrukcja obsługi (19 strony)

Installation

IMPORTANT

This hob must be installed by qualified

personnel to the relevant British Standards.

Any gas installation must be carried out by

a registered CORGI installer.

The manufacturer will not accept liability,

should the above instructions or any of the

other safety instructions incorporated in this

book be ignored.

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using

excessive force.

Connection to the gas supply should be with either

rigid or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to

RC 1/2 (1/2 BSP male thread).

When the final connection has been made, it is

essential that a thorough leak test is carried out on the

hob and installation.

Ensure that the main connection pipe does not exert

any strain on the hob.

It is important to install the elbow correctly,

with the shoulder on the end of the thread,

fitted to the hob connecting pipe.

Failure to ensure the correct assembly will

cause leakage of gas.

Cut Out Size

The dimensions of the cut-out are given in the

diagram.

FO 0264

A) End of shaft with nut

B) Washer

C) Elbow

Rectangular cut-out size for hob

Dimensions are given in mm.

FO 2038

FO 0814

560

150 min