Zanussi ZGLR 646 Instrukcja obsługi i instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Hob Zanussi ZGLR 646. Zanussi ZGLR 646 11 stron.
Również dla Zanussi ZGLR 646: Instrukcja obsługi i instalacji (12 strony), Instrukcja obsługi i instalacji (12 strony)
Drukuj stronę
Instruction for the User
Hob Burners Control Knobs
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
there is no gas supply
"
there is maximum gas supply
there is minimum gas supply
Lighting the Burners
•
For easier lighting, proceed before putting a pan
on the pan support.
! ! ! ! !
To light a burner, push the electric ignition button
which is marked by a little spark.
At the same time, push in the relevant knob and
turn it anticlockwise to "maximum position". After
lighting the flame, keep the knob pushed down for
about 5 seconds. This will allow the "thermocouple"
(Fig. 1 - lett. D) to be heated and the safety device
to be switched off, otherwise the gas supply would
be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" and "crown" (Fig. 1 -
lett. A-B) is in the correct position.
To put the flame out, turn the knob to the symbol
""".
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
•
Always turn the flame down or put it out before
taking the pans off the burner.
Using the hob correctly
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame
will not spread beyond the bottom of the vessel (see the
table beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
Use only pans or pots with flat bottom.
Carefully supervise cookings with fats or oil,
since these types of foodstuff can result in a fire,
if over-heated.
4
Fig. 1
A - Burner Cap
B - Burner crown
C - Spark generator
D - Thermocouple
Burner
minimum
Big (rapid)
Medium (semirapid)
Small (auxiliary)
maximum
diameter
diameter
180 mm.
260 mm.
120 mm.
220 mm.
80 mm.
160 mm.