Zanussi ZGW 1302 X Instrukcja obsługi i montażu - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi i montażu dla Hob Zanussi ZGW 1302 X. Zanussi ZGW 1302 X 11 stron. Ceramic built-in hobs
Również dla Zanussi ZGW 1302 X: Instrukcja obsługi i montażu dla klienta (12 strony)
Drukuj stronę
Cut out worktop to prescribed
measurements of templates (saw
exactly along the scribing).
Check seal for perfect fit and
overall cover (see detail A).
Lower the ceramic hob into place
and align correctly.
Tighten bracket against the underside of the worktop.
Using a standard or Phillips screwdriver, tighten the
tension clamps evenly starting at the centre and
moving diagonally until the built-in rim is tight on the
worktop.
Do not overtighten!
Do not use an electric or pneumatic sdrewdriver
without an adjustable safety clutch (pos. 1-1.1 Nm).
The installation of the control box or the oven will be
carried out according to separate instructions. In order
not to damage the appliance, the hob may only be
connected to control boxes which are approved by the
supplier of the ceramic hob.
The distance between the underside of the hob and the
furniture underneath must be at least
If there are any repairs to be effected, the
appliance must be non-tensioned (e.g. by
unscrewing the fuse).
As soon as a crack is visible in the top,
the appliance has to be disconnected from
the mains.
(see fig.2).
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3