Zanussi ZKT 651 D Instrukcja instalacji i obsługi - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Hob Zanussi ZKT 651 D. Zanussi ZKT 651 D 28 stron. Ceramic glass induction hob
Drukuj stronęWhat to do if ...
Problem
The cooking zones will not switch
on or are not functioning
The residual heat indicator is not
displaying anything
The automatic warm up function is
not switching itself on
Repeated acoustic signal (6x), ap-
pliance switches off
Acoustic signal sounds and appli-
ance switches itself on and then off
again; after 5 seconds another
acoustic signal sounds
Display is switching between two
heat settings
f
flashes
_ is lit
e and number are displayed
Possible cause
More than 10 seconds have passed
since the appliance was switched
on
The lock is switched on
The child safety device is switched
l
on
Several sensor fields were touched
at the same time
The sensor fields are partly covered
by a damp cloth or with liquid
Safety cut-out has been triggered
The cooking zone was only on for a
short time and is therefore not hot
There is still residual heat on the
cooking zone h
The highest heat setting is set Ç
One or more sensor fields have
been covered for longer than 10
seconds
The On/Off sensor field has been
covered up, e.g. by a cloth
Power management is reducing the
power of this cooking zone
Unsuitable cookware
No cookware on the cooking zone
The diameter of the bottom of the
cookware is too small for the cook-
ing zone
Overheating protection for the
cooking zone has been triggered
Electronics fault
Switch the appliance on again.
l
Switch off the lock (See the section
"Locking/unlocking the control
panel")
Deactivate the child safety device
(See the section "Child safety de-
vice")
Only touch one sensor field
Remove the cloth or the liquid.
Switch the appliance on again.
Switch the appliance on again
If the cooking zone is supposed to
be hot, call your local Service Force
Centre.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic warm
up function
Uncover sensor field
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's
wiring system)
If after switching on again, e is dis-
played again, call the customer
service department
Remedy
17