Zanussi ZKT 662 HX Instrukcja obsługi - Strona 23

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob Zanussi ZKT 662 HX. Zanussi ZKT 662 HX 25 stron. Ceramic built-in hob
Również dla Zanussi ZKT 662 HX: Instrukcja obsługi (26 strony)

Drukuj stronę

Installation dimensions

The opening in the cabinet must correspond to the

standard dimensions. The necessary information can

be found in the dimensional sketch.

The separation between the lower surface of the

hob and the parts of the furniture below it must be

at least 20 mm.

The lateral separation between the sides of the

hob and the cabinet must be at least 50 mm, and

must be at least 50 mm from the rear panel.

This appliance conforms to Type Y (IEC 335- -2- -6)

with regard to fire protection. Only appliances of

this type may be installed on one side of adjacent

cabinets or walls.

Installation

1. Cut out the worktop according to the prescribed di-

mensions (Fig.1). (Saw exactly along the scribed

line.)

2. Fix according to Fig. 2

Position A must be used for screwing--on the catch

springs (Fig.1).

Important: The screw must be driven into the worktop

as illustrated.

Avoid overtightening. Do not use electric or pneumatic

screwdrivers unless they have, adjustable slipping

clutches (set to 1--1.1 Nm).

3. Check the sealing for proper fit and full contact.

4. Place the ceramic hob in the cut--out.

Removing the glass- -

ceramic hob

1. Disconnect the appliance from the electrical sup-

ply.

2. Push the hob upwands from underreath.

166

min. 50 mm

min. 50 mm min. 50 mm

20 mm

Fig.1

Fig.2

1 Catch spring

2 Screws

3 Worktop

20 mm

4 Frame

5 Sealing tape

6 Glass ceramic plate