Zanussi ZBF22451SA Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka Zanussi ZBF22451SA. Zanussi ZBF22451SA 16 stron.
Również dla Zanussi ZBF22451SA: Podręcznik użytkownika (16 strony), Podręcznik użytkownika (16 strony), Podręcznik użytkownika (17 strony), Podręcznik użytkownika (45 strony)
Drukuj stronę
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Fast Freeze
button, or after changing
the temperature.
Temperature cannot be
set.
The temperature in the ap-
pliance is too low/high.
Upper or lower square is
shown in the temperature
Display.
dEMO appears on the Dis-
play.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Service Center .
Closing the door
1. Clean the door gaskets.
8
Possible cause
The temperature is not set correct-
ly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
This is normal, no error has occur-
red.
Fast Freeze function is switched
on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
An error has occurred in measur-
ing the temperature.
The appliance is in demonstration
mode (dEMO).
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
The compressor starts after a period
of time.
Switch off Fast Freeze manually, or
wait to set the temperature until the
function has reset automatically. Re-
fer to "Fast Freeze function".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Call your service representative (the
cooling system will continue to keep
food products cold, but temperature
adjustment will not be possible.)
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
www.zanussi.com