Zanussi ZFC26500WA Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka Zanussi ZFC26500WA. Zanussi ZFC26500WA 12 stron.

Drukuj stronę

Installation

WARNING!
Refer to Safety chapters.
Positioning
CAUTION!
If you are discarding an old
appliance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
The appliance shall have the plug
accessible after installation.
Electrical Connection
CAUTION!
Any electrical work required to install
this appliance should be carried out
by a qualified electrician or
competent person.
10
WARNING!
This appliance must be earthed.
The manufacturer declines any
liability should these safety
measures not be observed.
The wires in the mains lead are coloured in
accordance with the following code:
A
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either with the
letter "E" or by the earth symbol
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or
coloured red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure
over the outer sheath.
Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
5. Switch on the appliance.
B
C
D
E
or
www.zanussi.com