Zanussi ZFT 13 JD Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamrażarka Zanussi ZFT 13 JD. Zanussi ZFT 13 JD 14 stron. Freezer zft 13 jd

Drukuj stronę
GB
Place a tray of sufficient height in front of the product.
Following the arrow, carefully pull out the defrost
water drain, located in the central bottom section of
the product, to let the defrost water flow into the tray.
The defrosting process will be quicker if you put a
pan filled with hot water on the cooling plates used
as shelves.
Once defrosting is completed, dry the wet surfaces
and push back the defrost water drain.
Connect the product to the mains.
Rotate the thermostat to position <<-18°C>> and let
the product operate in quick freeze mode for at least
2 hours before putting back the formerly removed
frozen foods.

Regular cleaning

It is practical to clean the inside of the freezer and
defrost it at a time.
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance using
lukewarm water and wipe it.
Problem
The appliance does not cool
sufficiently
The appliance cools too hard
The appliance does not cool
at all
The appliance is noisy
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The
product will continue to operate with the use of a reserve system until the problem is eliminated by the local service
personnel.
38
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was not precooled
sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too high.
Plug is not connected to the mains socket
properly.
There is no voltage in the mains socket.
Thermostat set to "0" position.
The appliance is not supported properly.
Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt
collected on the back of the appliance and the
condenser once or twice a year.

When the refrigerator is not in use

If you do not use the product for longer periods,
make sure to perform the following:
Set the thermostat to position <<
Disconnect the product from the mains.
Remove all foods from the product.
Perform defrosting and cleaning operations as
described above.
Leave the doors ajar to avoid the build-up of
unpleasant odors.

Trouble shooting

During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information
is
given
unnecessary charges on service.
We draw your attention that operation of appliance
goes with certain sounds (compressor- and
circulating sound). This is not trouble, but means
normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the electrical
parts of the appliance before removing it from the
mains socket.
Set higher position.
Pre-cool the appliance for enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check thermostat setting.
Check if the appliance stands stable (all the four
feet should be on the floor).
>>.
about
them
to
avoid
Solution