Zanussi ZFT 410W Instrukcja obsługi - Strona 33

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamrażarka Zanussi ZFT 410W. Zanussi ZFT 410W 48 stron.

Drukuj stronę

Regular cleaning

It is practical to clean the inside of the freezer and defrost

it at a time.

Household cleaner or soap must not be used.

After breaking the circuit wash the appliance using

lukewarm water and wipe it.

Clean the door gasket with clean water.

After cleaning apply voltage to the appliance.

It is recommended to remove the dust and dirt collected

on the back of the appliance and the condenser once or

twice a year.

When the refrigerator is not in use

In case the appliance will not be used for a long time

follow these steps:

Remove plug from the mains socket.

Remove foods from the refrigerator.

Defrost and clean it as written before.

Leave the door open to avoid a build up of air inside.

Problem

The appliance does not

cool sufficiently

The appliance cools too

hard

The appliance does not

cool at all

The appliance is noisy

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Technical data

Model

Gross capacity (l)

Net capacity (l)

Width (mm)

Height (mm)

Depth (mm)

Energy consumption

Energy class, according to EU Standards

Freezing capacity (kg/24h)

Rising time (h)

Rated power (A)

Weight (kg)

Downloaded from Fridge-Manual.com Manuals

Possible cause

Thermostatic control is set too low.

Before freezing the appliance was not precooled

sufficiently.

Large-sized food was put in.

Too many foods to be frozen were put in.

Warm foods were put in.

Door is not shut properly.

The thermostatic control is set too high.

Plug is not connected to the mains socket properly.

There is no voltage in the mains socket.

Thermostatic control is in „0" position.

The appliance is not supported properly.

Instructions for the Installer

(kWh/day)

(kWh/year)

Trouble shooting

During operation of the appliance some smaller but

annoying trouble can often occur, which does not require

calling a technician out. In the following chart information

is given about them to avoid unnecessary charges on

service.

We draw your attention that operation of appliance goes

with certain sounds (compressor- and circulating sound).

This is not trouble, but means normal operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-current.

That is why you must not touch the electrical parts of the

appliance before removing it from the mains socket.

Set higher position.

Pre-cool the appliance for enough time.

Cut up food.

Put fewer foods to be cooled.

Put foods max. at room temperature.

Check if the door is shut.

Set lower position.

Check if the connection is proper.

Check if there is voltage.

Check setting of thermostatic control.

Check if the appliance stands stable (all the four

feet should be on the floor).

ZFT 410 W

110

550

850

612

0,567

207

0,8

Solution