Zanussi ZFT11105WA Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka Zanussi ZFT11105WA. Zanussi ZFT11105WA 16 stron.

Zanussi ZFT11105WA Podręcznik użytkownika

Operation

Control panel

Green Indicator Light
1
Red Indicator Light
2
Temperature Regulator
3
Switching on
Leave the appliance to stand upright for 4 hours
after installation.
Insert the plug into the wall socket.
1. Turn the Temperature Regulator clockwise
to the Full Loaded position.
The Green Indicator Light will light up and
remain lit until the appliance is switched off.
2. Leave to run for 8 hours to allow the correct
temperature to be reached before placing
food inside.
The Red Indicator Light will stay on until the
correct temperature is reached.
3. When the appliance has reached the set
temperature (the Red Indicator Light has
gone out) adjust the Temperature Regulator
according to the quantity of the stored
foods.
A few hours after starting up the
Red Indicator Light will go out to
show that the correct temperature
has been reached for the setting
chosen and will stay out to indicate
that everything is in order. It will
come on if the freezer temperature
rises unduly for instance, after
opening the freezer door or placing
food inside the cabinet, but the light
should go out again when the
temperature returns to the correct
storage level.
www.zanussi.com
2
1
Half Loaded position
4
Full Loaded position
5

Switching off

1. To turn off the appliance, turn the
Temperature Regulator to the "O" position.
2. To disconnect the appliance from the
power, disconnect the mains plug from the
wall socket.

Temperature regulation

The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward
lower settings to obtain the minimum
coldness.
• turn the Temperature Regulator toward
higher settings to obtain the maximum
coldness.
In case of freezing less food
volumes, the Half Loaded setting is
the most suitable. In case of freezing
large food volumes, the Full Loaded
setting is the most suitable.
3
4
5
0
5