Zanussi ZFU 319 EW Instrukcja obsługi - Strona 43
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamrażarka Zanussi ZFU 319 EW. Zanussi ZFU 319 EW 48 stron.
Drukuj stronę
After breaking the circuit wash the appliance using
lukewarm water and wipe it.
Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt collected
on the back of the appliance and the condenser once or
twice a year.
When the refrigerator is not in use
If you do not use the product for longer periods, make
sure to perform the following:
Set the thermostat to position <<
Disconnect the product from the mains.
Remove all foods from the product.
Perform defrosting and cleaning operations as described
above.
Leave the doors ajar to avoid the build-up of unpleasant
odors.
Problem
The appliance does not cool
sufficiently
The appliance cools too hard
The appliance does not cool
at all
The appliance is noisy
Green indicator flashing
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will
continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel.
Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption
Energy class, according to EU Standards
Freezing capacity (kg/24h)
Rising time (h)
Rated current (A)
Weight (kg)
>>.
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was not precooled
sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too high.
Plug is not connected to the mains socket
properly.
There is no voltage in the mains socket.
Thermostat set to "0" position.
The appliance is not supported properly.
Temperature sensor problem.
Instructions for the Installer
ZFU 319 EW
190
168
545
1250
639
(kWh/day)
0,685
(kWh/year)
250
A
20
18
0,7
45
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-current.
That is why you must not touch the electrical parts of the
appliance before removing it from the mains socket.
Set higher position.
Pre-cool the appliance for enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check thermostat setting.
Check if the appliance stands stable (all the four
feet should be on the floor).
Call the service personnel.
G G B B
Solution
43