Directed Directechs DB3 Instrukcja instalacji - Strona 10

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

Wait until the LED turns ON solid red.

Enable the CAN bus by pressing the Unlock button on the OEM remote, the Unlock

button on the inside of the door, or by pressing and releasing the door pin switch. The

LED starts flashing orange quickly.

Note: To skip bypass, wait until the LED turns ON solid orange, then press the

programming button 5 times, before proceeding with the next step to continue

programming. This will only program convenience features then proceed to step 6.

Insert the key in the ignition barrel. The LED turns OFF. Wait until the LED turns back

ON solid orange to indicate the key is in learning mode (this may take up to 20

seconds).

Note: If the LED turns ON solid green, then shuts OFF, a module has already been

programmed into the vehicle.

Turn the key to the ON position. The LED starts flashing green quickly after a few

seconds (this may take up to 5 seconds).

Turn the key to OFF, and removethe keyfrom the ignition barrel. The LED keeps

flashing green quickly. Wait for the LED to start flashing orange slowly (this may take

up to 20 seconds).

Insert and turn the key to ON, then OFF, before removing the key. The LED starts

flashing green slowly.

Wait for LED to turn ON solid green or orange for 3 seconds, before shutting OFF (this

may

take up to 90 seconds).

Green: The bypass was successfully programmed.

Orange: The bypass programming was skipped in favor of only programming the

convenience features.

You have successfully completed the module programming sequence.

403.TL5 4.00 2012 Toyota Avalon (G Key)