Zanussi ZHC 916X Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Okap wentylacyjny Zanussi ZHC 916X. Zanussi ZHC 916X 21 stron. Cooker hood
Również dla Zanussi ZHC 916X: Instrukcja obsługi (24 strony)

Drukuj stronę

INSTALLATION INSTRUCTIONS

Draw a vertical line on the wall from the centre of the

cooking appliance, using a spirit level and marking pen.

This is to ensure the correct level of alignment of the

appliance (5).

Mark the hole position (1) on the wall 100mm either side

of the vertical line ensuring that they are level and that

the distance between the lowest point of the hood and

the cooking appliance beneath meet the clearance

requirements quoted in the paragraph titled 'Clearance

Heights' (* - Page 12).

Using an 8mm masonry bit, drill the holes for the canopy

and insert a suitable wall fixing plug ready for the fixing

screws.

Fix the round eyelet screws provided tightly into the holes

(Fig.6).

Fitting the hood canopy

Remove the metal grease filter and the activated

charcoal filter, if there are any (see Maintenance &

Cleaning).

Fit the support rod B using the two screws K (3.5 x 9.5)

provided.

Not supplied

Hook the hood canopy C to the eyebolts O fixed in hole

(1). Adjust the support rod B so that it pushes against

the wall, keeping the canopy horizontal.

The support rod must be correctly fixed and adjusted.

It must not be removed until the installation has been

completed and checked.

Failure to ensure correct fixing could cause the canopy

fixing hooks and eyelet bolts to be damaged or distorted.

This may compromise the safety of the installation.