Directed Directechs DB3 Instrukcja instalacji - Strona 4

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

OEM Alarm triggering: If the OEM alarm triggers upon remote start, enable the Safelock setting when flashing the module.

If the OEM alarm triggers after remote start, set a (-) output for Ignition and connect it to Keysense. Refer to Tech tip 1308.

Driver Priority Unlock: If the vehicle is equipped, drivers' priority unlock must be configured via User Settings mode on the cluster

(must also be set during module flashing):

•All Doors Unlock - Set the Two Press Unlock setting to OFF

•Driver Priority Unlock - Set the Two Press Unlock setting to ON

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the Vehicle connections section following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

[2] Tach: An optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] EMS COM: This connection is not required in US vehicles without transponder.

[4] OEM Remote: The connection is only required to maintain OEM remote functionality during remote start. The TPMS light will come

ON during runtime or idle mode and will go out after vehicle takeover.

403.HK18 1.18 2023 Kia Seltos

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation