Zanussi ZCG43330BA Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kuchenki Zanussi ZCG43330BA. Zanussi ZCG43330BA 28 stron.
Drukuj stronęnecessary, remove stubborn stains with a
paste cleaner.
3. After you clean the pan supports, make sure
that they are in correct positions.
4. For the burners to operate correctly make
sure that the arms of the pan supports are
aligned with the centre of the burner.
Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not, the
dirt can cause damage to the hob.
Oven - Daily use
WARNING!
Refer to Safety chapters.
Cooling fan
When the appliance operates, the cooling fan
activates automatically to keep the surfaces of
the appliance cool. If you deactivate the
appliance, the cooling fan can continue to
operate until the appliance cools down.
If there is a defect in the cooling fan,
contact the Authorised Service
Centre.
Ignition of the oven burners and the
grill
CAUTION!
When the oven is active, the lid has
to be opened to avoid over-heating.
Keep the oven door open when you
ignite the burner.
Oven safety device: The oven
burners have a thermocouple. It
stops the gas flow, if the flame goes
out.
You cannot operate the top oven
burner, when the grill is active.
1. Open the oven door.
2. Push the knob for the top oven and turn it
counterclockwise to
oven burner.
• Push the knob for the top oven and turn
it clockwise to
burner.
10
to ignite the top
to ignite the grill
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat stains,
shiny metallic discoloration. Clean the hob
with a moist cloth and some detergent. After
cleaning, rub the hob dry with a soft cloth.
Cleaning the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode. Keep
these components well clean to prevent difficult
lighting and check that the burner crown holes
are not obstructed.
• Push the knob for the main oven and
turn it counterclockwise to
the main oven burner.
3. Keep the knob pushed for equal or less
than 15 seconds to let the thermocouple
warm up. If not, the gas flow is interrupted.
4. After ignition release the knob, close the
oven door and turn the knob to set the
necessary heat setting.
WARNING!
Do not push the knob for more than
15 seconds. If the oven burner does
not light after 15 seconds, release
the knob, turn it back to off position
and try to light the oven burner again
after minimum 1 minute.
CAUTION!
In the absence of electricity you can
ignite the oven burner without an
electrical device. In this case open
the oven door, put the flame near the
hole in the bottom of the oven cavity,
turn the knob to the spark position
and push it down. Keep the knob for
the oven functions pushed for equal
or less than 15 seconds to let the
thermocouple warm up.
If the oven burner accidentally goes
out, turn the knob for the oven
functions to the off position and try
to light the burner again after
minimum 1 minute.
Turning off the oven burners
To put out the flame, turn the knob to the off
position.
to ignite
www.zanussi.com