Zanussi ZCG92286 Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kuchenki Zanussi ZCG92286. Zanussi ZCG92286 28 stron.
Drukuj stronęIgnition of the hob burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a hob burner with the
thermocouple
• For manual ignition put the flame near the
burner. Push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position
.
• For ignition with spark generator button push
and hold the spark generator button
the same time push the knob for the hob
down and turn it counterclockwise to the
maximum gas flow position
spark generator button when burner lights.
• For integrated ignition on knob push the
knob for the hob down and turn it
counterclockwise to the maximum gas flow
position
.
Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the burner
does not light after 15 seconds,
release the knob, turn it into the off
position and try to light the burner
again after minimum 1 minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
www.zanussi.com
Burner overview
. At
. Release the
A) Burner cap
B) Burner crown
C) Ignition candle (if applicable)
D) Thermocouple (if applicable)
Turning the burner off
To put the flame out, turn the knob to the off
position
If the burner accidentally goes out,
turn the knob to the off position and
try to light the burner again after
minimum 1 minute.
.
A
B
C
D
A
B
C
D
9