Zanussi ZCM5150 Instrukcja obsługi - Strona 21

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kuchenki Zanussi ZCM5150. Zanussi ZCM5150 21 stron. 50x50 electrogas cooker

Replacement of the nozzles

Every appliance has spare nozzles for every gas.

The whole of every nozzle is marked in microns

on the nozzle.

For changing the nozzles:

1. Remove the pan support;

2. Remove the burners;

3. Using a socket spanner 7 unscrew the

nozzles (fig. 23) and replace them with those

required for the type of gas in use.

Put in place the burners and the pan supports.

Adjustment of minimum level for the hob

burners

The burner is correctly adjusted when the flame

is stable silent and goes out without any noise.

When changing the type of gas check that the

minimum level is correct. The air admission is

correct when the flame is about 4 mm in length.

The top burners do not need adjustment of

primary air.

Check that, turning the knob quickly from the

maximum position to the minimum one, the flame

does not go out.

Flame adjustment

To adjust the minimum level:

•

Light the burner

•

Turn the knob to the position of the minimum

flame;

•

Remove the knob;

•

Unscrew or screw the by-pass screw (below

of tap shaft) until a regular small flame is

reached.

•

For LPG screw completely the by-pass

screw.

Reassemble the parts following the same

procedure in reverse.

Check that, when turning the knob quickly from

the maximum position to the minimum one, the

flame does not go out.

fig. 23

fig. 24