Clarke CHAMP 262 Instrukcja obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprężarka powietrza Clarke CHAMP 262. Clarke CHAMP 262 12 stron.

Maintenance

Always disconnect the compressor from the electrical supply and completely

drain the air from the receiver before any maintenance or repair.

Simple routine maintenance will improve the performance of your compressor,

and help to prolong its life.

After the first 5 hours of operation, check the cylinder head and motor bolts, and

tighten any which may be loose.

After the first 100 hours of operation, change the crankcase oil. Drain the oil by

unscrewing the crankcase drain plug (see figure 5). Refill to the maximum mark

on the dipstick with Clarke SAE 40 compressor oil.

Daily

Check the oil level and top up if necessary with

Clarke SAE 40 compressor oil. The oil level should

be between the minimum and maximum marks

on the dipstick (see figure 2).

Drain any water from the air receiver by

unscrewing the drain cock under the receiver.

Every 50 hours

Clean the air filter after every 50 hours of

operation (more frequently if the compressor is

used in a dusty environment). Unscrew the filter

and clean it by carefully blowing through with

compressed air against the normal direction of

air flow. Replacement air filters are available

from our Spares Department.

Clean the outside of the compressor, particularly

around 3the motor, to allow proper cooling.

Every 500 hours

Change the crankcase oil (as above). Check

and clean the non-return valve (see figure 6).

Air Receiver Safety Valve

Do not attempt to adjust or overhaul the air

receiver safety valve. If the valve becomes faulty,

a replacement safety valve must be fitted.

Contact our Spares Department for advice.

CAUTION!

(approx. 6 monthly)

Fig.5

Fig.6

Fig.7