Clarke Raider 105 Instrukcja obsługi i konserwacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprężarka powietrza Clarke Raider 105. Clarke Raider 105 17 stron. 3hp direct drive compressor
Drukuj stronę
OPERATION
1. Insert the mains plug into the mains socket and switch on the power.
• The mains voltage must be 230V.
2. Lift the red On/Off switch.
• The compressor will make a
continuous loud noise when the
tank is charging - this is normal.
• The compressor will charge the
main tank to 8 bar (116 psi) then
switch off.
• The compressor will restart
automatically whenever the
pressure in the main tank falls
below a certain level.
3. Check the safety valve daily by
pulling on the ring attached.
• Air should be released you pull
the ring and stop when
released.
• If the valve does not operate as
described, or if the valve is
stuck, it must be replaced by
qualified service personnel
before using the compressor.
WARNING: DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.
4. Select the pressure you need using
the pressure regulator. (if fitted)
7