Directed Directechs DB3 Instrukcja instalacji - Strona 5

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Runtime:

•This firmware has a 10 minutes runtime and cannot be modified.

•The parking lights will flash every two seconds during runtime, by default. If this does not occur, you can select a different option in

the Data Feature Configuration when flashing your module.

SmartStart Compatible: SmartStart is equipped with D2D, which means it can be connected to an interface module.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Conditions and Limitations

Vehicle must be locked and armed for at least 45 seconds before remote starting.

The remote start system will not work in the following conditions:

The vehicles ignition has not been cycled for 4 days or more.

The ignition is on.

The alarm system is triggered.

The doors/hood are open.

The transmission is not in Park (P).

The vehicle battery voltage is too low.

The service engine light is on.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if

not supported in data.

403.HKRS03 1.02 2021 Kia K5 2.5L Turbo (Smart Key)

Refer to the Quick Reference Guide section for more details.

Keys

Keys required

required for

for operation

programming