Directed Directechs DB3 Instrukcja instalacji - Strona 5

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

Important!

The firmware does not control the OEM alarm. Remove the battery in the OEM remote to prevent the vehicle

from arming. The vehicle's OEM alarm will no longer be functional. The installation of a hybrid system (remote starter and

alarm combo) is highly recommended to preserve vehicle security.

Key2GO is mandatory to control the immobilizer override in this firmware.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle connections" following the installation diagram.

General notes: This section highlights important information for this specific firmware.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin or

[2]

not supported in Data.

The Key Release connection is only required if Pit Stop Mode is desired.

[3]

For trunk release to operate, ALL doors need to be unlocked first.

[4]

403.CHRYSLER12 1.24 2019 Dodge/Ram ProMaster City

Keys required for

programming

operation